24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Epoxy or polyester resin as an insulator?

Epoxy resin usually outperforms polyester in adhesion, dimensional stability, chemical resistance and electrical properties under humidity, while polyester is less expensive, cures quickly and serves in less demanding applications.

Why they differ

Both are thermosetting resins that cure by forming a three-dimensional network. Epoxy cures through a reaction between epoxy groups and a hardener, with little release of by-products. Unsaturated polyester cures by free-radical polymerization with a reactive monomer, such as styrene, and shows greater shrinkage on curing.

Practical comparison

Aspect Epoxy Polyester
Adhesion to metals and reinforcements Very good Lower
Cure shrinkage Low Higher, with internal stresses
Behavior in the presence of moisture Generally better More sensitive to hydrolysis
Chemical resistance Broad, depends on the hardener Good in general, lower against alkalis
Cost and process speed Normally higher Lower, fast cure

What this means for electrical insulation

The lower shrinkage of epoxy reduces stresses and microcracks around inserts and conductors, which would be partial discharge sites. Its good adhesion prevents voids at the interface. That is why it is used for transformer encapsulation, medium- and high-voltage insulators and laminates for circuit boards. Polyester appears in general-purpose laminates, molded parts and applications where cost rules.

Factors that qualify the choice

  • The hardener and fillers greatly change the properties of epoxy; there is no single epoxy.
  • The service temperature depends on the formulation and on complete curing.
  • The styrene in polyester entails ventilation and handling requirements.

What the engineer sees

In service with humidity and stress, polyester tends to show loss of properties sooner. In parts with metal inserts, cracks next to the insert are a typical symptom of excessive shrinkage.

When the rule does not apply

For simple indoor, low-voltage, low-cost applications, polyester may be sufficient. Always compare specific material datasheets and validate with tests.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer