24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is the fill factor?

The fill factor compares a module's actual maximum power with the product of its open-circuit voltage and short-circuit current; it shows how square the I-V curve is and reflects cell quality.

Definition

The fill factor, abbreviated FF, is the ratio of the power at the maximum power point to the product of the open-circuit voltage and the short-circuit current. That product is the power of an ideal rectangle that no real device reaches. The FF measures what fraction of that rectangle the I-V curve actually occupies. It is a dimensionless number less than one, or a percentage.

What the shape of the curve shows

An ideal curve would be almost square: constant current up to nearly the open-circuit voltage, then a vertical drop. The rounder the knee, the lower the FF. It is a compact measure of quality: two modules with the same extreme current and voltage values can have different power because their FF differs.

What reduces it

  • High series resistance: from poor contacts, metallization or wiring, which rounds the knee.
  • Low shunt resistance: internal leakage from defects or edges, which tilts the flat section of the curve.
  • Carrier recombination in the cell, which degrades the ideal diode behavior.
  • Mismatch between cells within the module, which distorts the overall curve.

How it is calculated

From a measured curve, take the current and voltage at the maximum power point, multiply them, and divide by the product of the open-circuit voltage and the short-circuit current. Because the FF is a quotient, it is less sensitive than absolute power to the exact irradiance value, although it does change with temperature and with irradiance, because parasitic resistances weigh more at high currents.

How to interpret the result

A low FF compared with the manufacturer’s reference or with similar modules points to a resistance problem: deteriorated contacts, ribbon solder joints, corrosion or microcracks. If the FF of the same module falls over time, the issue is usually degradation of the series resistance. Always compare under comparable irradiance and temperature conditions.

Measurements on illuminated modules involve live voltage: they must be carried out by qualified personnel, following the applicable safety regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer