What it measures
A perfectly pure, degassed insulating oil withstands very high electric fields. Real oil contains contaminants that distort the local field and make breakdown easier. The standardized test applies a rising voltage between two immersed electrodes until a discharge occurs, and the breakdown voltage is recorded. The dielectric strength measured this way is not an intrinsic property of the oil, but a measure of its fitness as an insulator under the conditions of the sample.
What it depends on
- Water: dissolved water markedly reduces the strength as it approaches saturation; free water in droplets reduces it much more. Strength falls with relative saturation, not so much with the absolute amount of water.
- Particles: cellulose fibers, metals and carbon align in the field and form conductive bridges. The effect is greater if moisture is also present, because the fibers absorb water.
- Dissolved gases and bubbles: bubbles have lower strength than the liquid and concentrate the field.
- Temperature and viscosity: they influence the mobility of particles and bubbles and the solubility of water.
- Test conditions: shape and spacing of the electrodes, rate of voltage rise, stirring and the settling time of the sample.
What it does not reveal
An oil with good strength can be aged, acidic or contain dissolved oxidation products, because these change the breakdown value little under a fast test voltage. It is therefore complemented by the dissipation factor, resistivity, water content and acidity.
What an engineer sees in practice
A decrease in strength between successive samples usually means moisture ingress or particle buildup. A large spread between consecutive breakdowns of the same sample suggests non-homogeneous contamination. Recovery after filtering or dehydrating the oil confirms that the cause was water or particles.
How to interpret the result
The value must be compared with the criteria of the method used and with the voltage class of the equipment, and the trend over time must be examined. A low result does not by itself identify the cause; it indicates that the water, the particles and the way the sample was taken need to be checked.