24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Oil dielectric breakdown testing

Dielectric breakdown tests measure the ability of an oil or other insulating material to withstand an increasing voltage without failing. For maintenance managers of high-voltage electrical equipment.

Dielectric breakdown test of insulating oil

What these tests measure

Dielectric breakdown tests evaluate the insulating properties of dielectric materials or fluids, such as oils, gases or solids, used in electrical equipment. They measure the ability of the material to resist breakdown of its insulation under an increasing voltage. They are essential for the safety, reliability and efficiency of high-voltage electrical systems.

Objectives and benefits

1. Quality of insulating materials

  • Determine the ability of an insulating material (oil, gas, wiring, etc.) to withstand high voltages without failing.
  • Dielectric materials insulate the conductive parts of equipment, prevent short circuits and protect people from electric shocks.
  • They reveal the maximum voltage a material withstands before it "breaks down" and lets current through, that is, when its insulating capacity has been exceeded.

2. Insulating oil quality

  • In oil, commonly in transformers, they measure its ability to act as an insulator.
  • Oil, especially mineral oil, prevents current from passing between conductive parts and dissipates heat in transformers. Its dielectric capacity is crucial to prevent electrical failures.
  • They verify the purity of the oil and detect impurities, such as water, metal particles or dissolved gases, that reduce its insulating capacity.

3. Contamination or deterioration

  • Over time, insulators degrade through aging, moisture, contamination or high temperatures.
  • Oil contaminated by water, particles or dissolved gases loses insulating capacity, and the risk of electrical failures increases. The tests detect these problems before serious failures occur.
  • In solid materials, they can also identify internal defects or impurities that affect the insulation.

4. International norms and standards

  • They are essential to verify that electrical equipment meets the standards of international organizations such as IEC (International Electrotechnical Commission), IEEE (Institute of Electrical and Electronics Engineers) and ASTM (American Society for Testing and Materials).
  • These standards specify the test procedures and conditions and serve as a reference for qualifying materials and equipment.

5. Equipment safety

  • They prevent serious failures such as short circuits, fires or equipment damage, by confirming that the insulators withstand the operating conditions.
  • Knowing the dielectric breakdown limit, the operator can decide on replacement or maintenance before the insulation is compromised.

6. Effectiveness of maintenance treatments

  • In transformers, the oil and other insulators can undergo purification or regeneration. The tests verify whether the intervention restored the insulating properties.
  • They are also used to check the quality of the oil or the condition of other insulators before and after maintenance.

7. Equipment performance

  • With insulators of high dielectric strength, equipment can operate at higher voltage levels without compromising its safety. This can translate into better performance and a longer service life.

8. Early risk detection

  • Dielectric breakdown indicates that an insulator is reaching the end of its service life or has been affected by adverse conditions. Periodic tests make it possible to act in time, for example by replacing the oil or the insulating materials.

In short, these tests make it possible to evaluate the quality of insulators, prevent failures and improve the reliability of electrical systems throughout their service life.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer