What they are
Cursors are markers that move across the screen and display a numerical value. Vertical cursors read time, and horizontal cursors read voltage or the value of the quantity being plotted. They are normally used in pairs to read the difference, usually called delta, so that you get a time interval or an amplitude difference. The inverse of the interval between two equivalent points on a periodic signal gives its frequency.
What they are used for
- Measuring the period, the width of a pulse or the delay between two events.
- Measuring amplitude, overshoot or the height of a step.
- Measuring the delay between two channels, as a basis for calculating phase shift.
- Verifying an automatic measurement, or measuring what the instrument does not calculate.
What determines their accuracy
The reading is no better than the information in the capture. The horizontal cursor is limited by the converter resolution and the chosen scale, and the vertical cursor is placed on samples separated by the sampling interval. If you adjust it with the time base highly compressed, one screen pixel represents many samples, and manual positioning is less accurate than with the scale expanded. This is why it is best to zoom in on the area of interest before placing the cursors.
Cursors and automatic measurements
Automatic measurements calculate parameters over the entire capture, whereas cursor measurements reflect the judgment of the person placing them. The former depend on the instrument’s definitions, for example how it determines the high level or the percentages of a rise time; cursors let you check that the definition is the one you need. If the two results differ, analyze the cause rather than choosing the one that suits you.
How to use them well
- Zoom in on the measurement area.
- Place them at equivalent, clearly identifiable points, such as the crossing of a defined level.
- Read the difference rather than the absolute values if what matters is an interval.
- Check that the channel selected for the cursors is the one you want to measure.