What it is and how it is built
The bench has a motor under test and a load machine, the dynamometer, joined by a shaft with a torque transducer. The load machine can brake the motor, drive it or hold a fixed speed. On the electrical side, a power analyzer measures what goes into the inverter and the motor, and a power supply or battery emulator feeds the assembly.
Control modes
- Constant speed: the dynamometer holds the speed and the motor adjusts its torque as commanded, useful for obtaining the torque curve.
- Constant torque: the motor is controlled in torque and the dynamometer absorbs the load at whatever speed results.
- Driving profile: variable speed and torque cycles are reproduced, like those of a vehicle, with inertia simulation.
A four-quadrant dynamometer operates in both directions of rotation and both directions of torque, so it can test traction and regenerative braking.
What is measured and why
With the mechanical power at the shaft and the electrical power at the terminals, efficiency is calculated point by point and a map is built on the torque-speed plane. Steady-state temperature rise, overload behavior and no-load losses are also measured. Thermal tests require operating long enough to reach a stable condition.
What to watch for in a setup
- Coupling alignment, to avoid vibration and torque errors.
- Torsional stiffness and natural frequency of the shaft, which must not coincide with the motor’s excitation frequencies.
- Calibration of the torque transducer and the speed measurement.
- Cooling of the motor and inverter as in the real application.
The bench combines high voltage, stored energy and rotating masses. Its operation is the responsibility of qualified personnel, with guards, emergency stops and applicable safety procedures.