Why a lithium battery needs one
Lithium-ion cells have a narrow operating window. Charging them above their maximum voltage, discharging them below the minimum or using them at unsuitable temperatures shortens their life and can be dangerous. In addition, cells connected in series are not identical, and without supervision the weakest one overcharges or discharges before the others.
Main functions
- Measurement: voltage of each cell or group of cells, pack current and temperatures at several points.
- State estimation: calculation of the state of charge and the state of health.
- Balancing: equalizing the charge between cells, by dissipating the excess in resistors (passive) or transferring energy between cells (active).
- Protection: limiting the current and opening the contactors in the event of overvoltage, undervoltage, overcurrent or excessive temperature.
- Communication: reporting its current and voltage limits to the vehicle and charger.
What an engineer sees in the field
The BMS is the source of most diagnostic data: per-cell voltages, temperatures, fault codes and cycle counters. A large difference between cells suggests imbalance or a degraded cell. A power limitation in cold or hot conditions is a protective action of the BMS, not a motor fault.
Limitations
The BMS cannot measure the state of charge or the state of health directly; it infers them from models and measurements, so they contain error. Nor does it prevent all risks: an internal cell defect can develop faster than the protection. The quality of the voltage and temperature measurement determines how well it works.
How it communicates
Inside the vehicle it usually uses communication buses such as CAN to deliver data to the other systems. In stationary storage, the same communication allows the inverter to adjust its charging and discharging to the actual limits of the battery.
Notice
The high-voltage systems of an electric vehicle or its battery can cause serious injury. Their inspection and repair must be carried out by qualified persons, following the manufacturer’s procedure and the applicable safety regulations.