24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What does the IEC 61000-4-4 fast burst standard cover?

IEC 61000-4-4 describes the immunity test for electrical fast transient bursts: the generator, the coupling networks and clamps, the arrangement over a reference plane and the classification of the result. Levels and criteria are defined by the product standard.

General scope

IEC 61000-4-4 is a basic standard in the IEC 61000 series. It deals with the immunity of electrical and electronic equipment to repetitive fast transients, such as those caused by interrupting inductive loads. It defines the method and the characteristics of the disturbance, not the level each product must withstand.

Elements it defines

  • Generator: the waveform of the individual pulse, the duration and repetition frequency of the bursts, and the output impedance.
  • Generator verification: how to check its signal with attenuators and an oscilloscope.
  • Coupling to power lines: a coupling/decoupling network that injects the bursts into the conductors without them reaching the supply network.
  • Coupling to signal and control lines: a capacitive coupling clamp for cables, with no direct contact.
  • Arrangement: reference plane, insulation of the equipment from the plane and length of the test cable.
  • Procedure and evaluation: application at each port with both polarities and observation of behavior during and afterward.

What it adds compared with other tests

Bursts are low in energy and therefore rarely damage the equipment; the interest lies in the broad spectral content and in the repetition. They reveal sensitivities in digital circuits, reset inputs, clock lines, communications and reference sources. It is a test that complements the surge test, which tests energy, and the electrostatic discharge test, which tests an isolated event.

How to use the information

  1. Identify which product standard applies and which ports and levels it requires.
  2. Design the filtering and protection of each port with that goal from the start.
  3. Run a preliminary sensitivity check with your own generator or with a laboratory.

Current edition

Details of verification, test levels and arrangement may differ between editions. Before planning a test, consult the current edition and the one cited by the product standard for your market. This guide only describes the scope in general terms.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer