24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What are the standard test conditions of a module?

Standard test conditions (STC) are the set of reference conditions under which a module's power is declared: an irradiance of 1000 W/m², a cell temperature of 25 °C and an air mass 1.5 solar spectrum.

What they define

There are three parameters: an irradiance of 1000 W/m² in the plane of the module, a cell temperature of 25 °C and a reference spectrum corresponding to an air mass of 1.5. Under these conditions the I-V curve of a module is measured and its rated power in peak watts is obtained, that is, the power shown on the nameplate.

Why they exist

A module’s power changes with light and temperature. Comparing products from different manufacturers requires a common reference. STC fulfill that role: they are reproducible laboratory conditions, not a typical operating environment.

Why real operation is different

  • Cell temperature in the sun is usually well above 25 °C, and power decreases with heat according to the module’s temperature coefficient.
  • Irradiance varies throughout the day and is rarely exactly the reference value.
  • The spectrum changes with the time of day, the atmosphere and cloud cover.
  • The angle of incidence and soiling reduce the light that enters.

What an engineer sees in the field

An array rarely delivers, as measured at the inverter, the sum of the nameplate powers of its modules. The difference is due to real conditions and system losses, and does not in itself imply a defect. To compare field measurements with the nameplate, the measurement is corrected to STC using standardized procedures and the uncertainty is stated.

An example of how to read it

If a module measures less than its nameplate value in a laboratory at STC, the difference must be checked against the tolerance declared by the manufacturer and the measurement uncertainty before concluding that a defect exists.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer