What is different about a fleet
A charger for individual use is tested as an isolated piece of equipment. In a fleet, many vehicles charge in the same window, normally at night, from the same transformer. So the test covers both the charger and the system it forms with the installation and the management software.
What is verified
- Energy delivery: that the current and power delivered match what was commanded, using an independent power analyzer.
- Energy metering: that the station’s meter agrees with the reference measurement, because costs and per-vehicle reports depend on it.
- Interoperability: that each vehicle model in the fleet starts, maintains and ends the session without faults, including vehicles at different states of charge and temperatures.
- Protections: response to ground leakage, loss of ground, overtemperature and pilot faults, using a vehicle simulator.
- Communication with the management system: the usual protocol between station and central system is OCPP; behavior on loss of the link is checked, for example whether the station keeps charging at a safe limit.
Load management
The most revealing test is to run all the chargers at once. It shows whether the total power respects the limit of the transformer and the service entrance, how power is shared among vehicles, what happens when a vehicle finishes or another arrives, and whether the fleet’s departure schedule is met.
Effects on the installation
With sustained simultaneous charging, the voltage and temperature of panels and cables are recorded, along with harmonic distortion and power factor at the point of connection. This shows margins that an individual test does not reveal.
How to interpret the results
The success criterion is that all vehicles finish with the energy they need before their departure time, with no trips or overloads. A short test with a single vehicle is not enough. Work on energized installations is a job for qualified personnel, under the applicable regulations.