24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is cell temperature measured during fast charging?

Cell temperature during fast charging is measured with thermocouples or NTC sensors attached to the hottest areas, with isolated acquisition and logging synchronized with the current.

Why the measurement location matters

During fast charging, the high current generates heat through the Joule effect and polarization inside the cell. The center of the cell and the tabs or terminals usually get hotter than the side surface. A sensor in a cool area underestimates the risk, so sensor placement is the central decision of the test.

Choosing the sensor

  • Thermocouples: small and fast-responding, suitable for instrumenting many positions.
  • NTC thermistors: normally used by the battery management system itself; they are useful for comparison, but their location is fixed by the design.
  • Optical fiber: immune to electrical noise and isolated, useful in high-voltage environments, at a higher cost.

How it is installed

The sensor is attached with good thermal contact, for example with thermally conductive tape or adhesive, and is kept from being cooled by the airflow or coolant differently from the surface. The coolant inlet and outlet temperatures and the ambient temperature are also logged, so that a heat balance can be closed.

Electrical problems

A thermocouple attached to a cell sits at the potential of that cell. In a series pack this potential can be high relative to ground, and the acquisition system must have isolated inputs suitable for the voltage. In addition, power converters inject noise that couples into millivolt signals; shielding and twisting the cables helps, and it is advisable to verify that the reading does not change when the charger switches.

What to check in the data

Temperature is plotted together with current and state of charge. What is informative is the heating rate, the difference between cells, and the difference between the end and the center of the pack. A sudden rise in a single cell suggests a high connection resistance. Work must be done with qualified personnel, because energized packs are being instrumented.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer