24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is an oscilloscope used to debug a switching converter?

To debug a switching converter, the oscilloscope is used to observe the switching node, the inductor current and the output, looking for overshoot, ringing, noise and behavior that changes with load.

Which signals matter

A switching converter produces fast, high-amplitude signals in a small space, so almost all problems become visible by relating three things: the voltage at the switching node, the current flowing through the inductor and the output voltage.

The switching node

It shows the duty cycle, the rise and fall times and the ringing after each transition, caused by parasitic inductances and capacitances. Excessive overshoot stresses the semiconductors and is a source of interference.

The inductor current

It is measured with a current probe or a sense resistor. Its triangular shape reveals the conduction mode, inductor saturation, which appears as a sharp increase in slope, and current limiting.

The output

It is examined with AC coupling and a short ground connection to see the ripple and spikes. Applying a load step shows the response of the control loop: a long overshoot or sustained oscillation indicates a small stability margin.

General procedure

  1. Start with the input supply at a reduced value and no load, and increase gradually.
  2. Trigger on the switching node and measure frequency and duty cycle.
  3. Compare the inductor current with what the design predicts.
  4. Apply load steps and observe the recovery of the output.
  5. Repeat at the extreme input and load conditions.

Measurement precautions

  • Use minimal ground connections, because fast edges are very sensitive to the probe loop.
  • If the probe is referenced to a node that swings, such as the high side of a bridge, use a differential or isolated probe, never the oscilloscope ground.
  • Verify that the probes can withstand the input voltage and the spikes.

How to interpret the result

If ringing on the switching node changes when you change the probe or connection, part of it may come from the measurement. If it stays the same, it points to the printed circuit layout or the choice of components. Measurements on energized circuits or at hazardous voltages must be made by qualified personnel, following the applicable safety regulations and using accessories with the appropriate category and rated voltage.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer