24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is a ferrite applied to a cable?

The complete cable (all its conductors together) is passed through a ferrite core placed as close as possible to the source or exit point, choosing a material whose loss region matches the frequency of the problem. It acts on common mode, not on the useful signal.

What a ferrite does

A ferrite core adds impedance to the current in the conductor passing through it. If the cable carries both outgoing and return paths inside the core, the differential currents (the useful signal) generate opposing fluxes that cancel, while the common-mode current produces a net flux and meets impedance. At the frequencies where the material is lossy, that impedance is resistive and dissipates the energy as heat.

How to apply it

  1. Identify the problem frequency and confirm that the common-mode current on the cable is relevant.
  2. Select the material: each ferrite mix is effective over a range of frequencies; datasheets show impedance versus frequency.
  3. Place it near the origin (at the equipment output) or at the point where the cable crosses the enclosure.
  4. Pass all the conductors, outgoing and return, through the same core; if only one passes through, the useful current is affected.
  5. Add turns if more impedance is needed: it grows approximately with the square of the number of turns, although the capacitance between turns limits the effect at high frequency.
  6. Measure before and after with the current clamp.

When it does not solve the problem

  • If the problem is differential, the ferrite does not reduce it.
  • If direct or low-frequency current flows in a single conductor through the core, it can saturate the core, which then loses its impedance.
  • The inserted impedance is compared with that of the circuit: in a high-impedance loop the effect is small, and in a low-impedance loop it is greater.
  • If the cable radiates because the noise couples outside the section with the ferrite, nothing changes.

How to interpret the result

A clear drop in common-mode current at the target frequency indicates that the ferrite is working. If the radiated emission does not change, the measured current was not the dominant mechanism and the search must continue. Ferrites are a correction and diagnostic resource; a design with proper filtering and references should not depend on them.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer