24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is a motor analyzed with an oscilloscope?

An oscilloscope lets you analyze a motor by observing its phase voltages and currents, the signals from sensors such as Hall effect sensors or encoders, and its behavior during startup, using suitable differential and current probes.

What you can see

A motor is a load that reveals itself in its electrical signals. With the oscilloscope you can study the current in each phase, the voltage applied by the drive, the back EMF and the position feedback signals, and relate them to the mechanical behavior.

What to measure and with what

  • Phase currents: with clamp-on current probes. Their shape reveals balance between phases, distortion, switching ripple and starting overcurrents.
  • Phase voltage: with a differential probe, because the winding is not referenced to ground. You see the pulse-width modulation pattern, and its average value is what the drive actually applies to the motor.
  • Back EMF: on an unloaded motor or with a phase disconnected, the voltage induced by rotation indicates speed and the shape of the field.
  • Position sensors: Hall sensors, encoders and resolvers, whose signals must have phase and levels consistent with the rotor position.

What problems it helps you recognize

  1. Imbalance between phases, which points to a damaged winding or a drive problem.
  2. Excessive current at startup or under load, or saturation of the magnetic circuit, which distorts the current.
  3. Incorrect sensor sequence or timing, which causes loss of torque or noise.
  4. Speed or current oscillations due to a poorly tuned control loop.
  5. Common-mode interference from the drive that affects the sensors and the measurement itself.

A combined analysis

Capturing current and voltage at the same time and multiplying them with a math function gives instantaneous power. Frequency analysis of the current can show components associated with mechanical or electrical asymmetries, provided the interpretation is backed by knowledge of the type of motor and its drive.

What to check first

Before interpreting, verify the probe scale factors, the delay compensation between voltage and current if you are calculating power, and that the probes can withstand the common mode of the drive. Measurements on energized circuits or at hazardous voltages must be made by qualified personnel, following the applicable safety regulations and using accessories with the appropriate category and rated voltage.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer