The energy flow
Energy starts at the high-voltage battery, as direct current. The traction inverter transforms it into alternating current of controlled frequency and amplitude and feeds the motor. By varying the frequency and the current, the inverter controls speed and torque. The motor is connected to the wheels through a reduction gear with a single fixed ratio or a few ratios.
Main components
- Battery pack: cells grouped into modules, with contactors, fuses and sensors.
- Battery management system (BMS): monitors each cell and protects the pack.
- Traction inverter and motor, which may be permanent magnet or induction.
- Onboard charger: converts alternating current from the grid into direct current to charge the battery.
- DC-DC converter: steps down the high voltage to supply the vehicle’s 12 V systems.
- Thermal management: cools or heats the battery, inverter and motor to keep them within their operating range.
Why it is efficient
An electric motor converts a far larger fraction of energy into mechanical work than a combustion engine does, and it delivers useful torque from low speeds. In addition, it can recover part of the energy during braking. Even so, there are losses in the battery, the inverter, the motor and the transmission, and in charging from the grid.
What an engineer observes in practice
Performance depends on temperature, driving style and climate control, which draws energy from the same battery. In cold weather, the battery delivers less power and heating reduces the range. Faults usually appear as BMS codes, poor insulation between the high-voltage system and the chassis, or power limitations due to temperature.
High-voltage insulation
The high-voltage system is insulated from the chassis and monitored continuously. If the insulation drops, the vehicle warns of it or disconnects, because a ground leak is a safety hazard.
Notice
The high-voltage systems of an electric vehicle or its battery can cause serious injury. Their inspection and repair must be carried out by qualified persons, following the manufacturer’s procedure and the applicable safety regulations.