24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is a fleet charger tested?

A fleet charger is tested by verifying energy delivery, communication with the actual vehicle models, protections, load management when several vehicles charge at once, and the effect on the site's installation and grid connection.

What is different about a fleet

A charger for individual use is tested as an isolated piece of equipment. In a fleet, many vehicles charge in the same window, normally at night, from the same transformer. So the test covers both the charger and the system it forms with the installation and the management software.

What is verified

  • Energy delivery: that the current and power delivered match what was commanded, using an independent power analyzer.
  • Energy metering: that the station’s meter agrees with the reference measurement, because costs and per-vehicle reports depend on it.
  • Interoperability: that each vehicle model in the fleet starts, maintains and ends the session without faults, including vehicles at different states of charge and temperatures.
  • Protections: response to ground leakage, loss of ground, overtemperature and pilot faults, using a vehicle simulator.
  • Communication with the management system: the usual protocol between station and central system is OCPP; behavior on loss of the link is checked, for example whether the station keeps charging at a safe limit.

Load management

The most revealing test is to run all the chargers at once. It shows whether the total power respects the limit of the transformer and the service entrance, how power is shared among vehicles, what happens when a vehicle finishes or another arrives, and whether the fleet’s departure schedule is met.

Effects on the installation

With sustained simultaneous charging, the voltage and temperature of panels and cables are recorded, along with harmonic distortion and power factor at the point of connection. This shows margins that an individual test does not reveal.

How to interpret the results

The success criterion is that all vehicles finish with the energy they need before their departure time, with no trips or overloads. A short test with a single vehicle is not enough. Work on energized installations is a job for qualified personnel, under the applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer