24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Why do machine bolts come loose?

Bolts come loose because vibration, cyclic stresses and surface settling reduce the clamping force until the joint no longer maintains it, and once it loses preload, movement and loosening accelerate.

The joint depends on preload

A bolt works like a stretched spring: the clamping force, or preload, keeps the parts compressed and friction prevents them from moving relative to each other. As long as the external load does not exceed that friction, the joint behaves as a single piece. Loosening begins when that preload is lost or when the external force overcomes the friction.

Main mechanisms

  • Transverse slip: vibration or side loads make the parts slip slightly on each cycle, and that movement can back the nut off.
  • Embedding: the asperities flatten after tightening and the joint loses part of its tension.
  • Relaxation and creep: soft materials, gaskets or paint under the joint yield over time.
  • Thermal cycles: differential expansion between materials changes the tension.
  • Incorrect tightening: low preload leaves the joint vulnerable.

What the engineer sees

Looseness in a machine’s base shows up as increased vibration, with multiple harmonics of running speed in the spectrum and sometimes subharmonic components. Phase differences between the machine and the base are detected, along with fretting marks around the joint and bolts with slack when torque is applied.

How it is prevented

  1. Apply the specified tightening with a calibrated tool and a defined procedure.
  2. Keep contact surfaces clean, flat and free of soft materials.
  3. Choose fasteners suitable for the stress and the vibration.
  4. Check the joint after the first hours of operation and periodically thereafter.

Correcting the cause of the vibration is also necessary: a bolt that repeatedly comes loose usually indicates an underlying problem.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer