Direct answer
Operating pressure is the pressure at which the equipment works under normal conditions. Test pressure is the pressure applied once, or periodically, to confirm that the equipment withstands it with margin and does not leak. Test pressure is higher than operating pressure, but it is defined by the design code, not by the operator’s judgment.
The three pressures worth distinguishing
- Operating pressure: the pressure of normal service, which can vary during the process cycle.
- Maximum allowable working pressure or design pressure: the limit used to calculate and certify the equipment; protective devices, such as safety valves, are set with reference to it.
- Test pressure: related to the design pressure by a factor established by the applicable code, which depends on the type of test and the materials.
The factor and the specific values must be taken from the current code, not from memory.
Why the test is higher
Testing at operating pressure only shows that the equipment withstands what is already expected. A test above it provides a safety margin and reveals defects that would not appear at normal pressure, such as a poor weld or a badly seated seal.
What an engineer sees
The equipment nameplate shows the design values and, sometimes, the test pressure. A common mistake is to use the test pressure as if it were an available working pressure. Another is to overlook lower-rated components connected to the system, such as instruments and accessories, which must be isolated during the test.
When it matters most
In planning a hydrostatic or pneumatic test, in selecting pressure gauges with sufficient range for the test, and in setting relief valves. Pressure testing is work for qualified personnel applying the code and the current safety standards.