24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Wireless Mesh or Point-to-Multipoint Network?

A mesh network forwards traffic through the nodes themselves and adapts to obstacles and failures, while a point-to-multipoint network connects all nodes to a central station, which is simpler and has more predictable latency but creates a single point of dependency.

Two topologies, two philosophies

In point-to-multipoint there is a central station, such as an antenna or an access point, and each node communicates directly with it. In a mesh, each node can communicate with several neighbors and forward the traffic of others, so that a message reaches its destination through successive hops.

Practical comparison

Aspect Point-to-multipoint Mesh
Coverage Each node must see the central station Extends through hops between nodes
Obstacles A node without line of sight is left isolated Traffic goes around the obstacle
Redundancy If the central station fails, the whole network goes down Alternative routes exist if a node fails
Latency Low and predictable, a single hop Grows with the number of hops
Capacity The central station’s capacity is shared Each hop consumes channel time
Complexity Lower Higher: routing, testing, diagnostics

Why mesh is not free

Forwarding consumes the radio medium. With nodes sharing the same channel, a multi-hop message occupies the air several times, and useful capacity decreases with the number of hops. Forwarding nodes must also stay awake, which complicates designs with battery-powered nodes.

When each one makes sense

  • Point-to-multipoint: when the nodes have line of sight to the central station, predictable latency and throughput are needed and simple management is preferred.
  • Mesh: when the geometry is difficult, there are changing obstacles or tolerance to failures of individual nodes is required, and traffic per node is modest.

What to check first

Before choosing, it is advisable to carry out a coverage study at the site, know the traffic per node and the maximum acceptable latency, and define what happens if the central station or a key node fails. A poorly planned mesh network can have bottlenecks at the nodes close to the gateway to the rest of the facility.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer