24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

Why overpressure damages a pressure sensor

A pressure sensor is damaged when the fluid deforms it beyond its elastic limit: the diaphragm stretches permanently or fractures, and the zero or the sensitivity is left altered.

What happens to the sensor

A pressure sensor measures the deformation of a diaphragm or elastic element. As long as the pressure does not exceed its limit, the deformation is elastic and reversible. If the limit is exceeded, the material enters the plastic region: it stays deformed, and that residual deformation alters the zero and, in some cases, the sensitivity. If the excess is greater, the diaphragm or the joint breaks and a leak or loss of containment of the fill fluid occurs.

Why it happens even when the rated pressure is correct

What causes the damage is not the operating pressure but the spikes. Water hammer from abrupt valve closure, a pump start, rapid pressurization with gas, or a hydrostatic test of the system with the sensor connected all generate spikes far above the steady value. In addition, cleaning or purging with compressed air can apply an unexpected pressure to the instrument.

What an engineer sees

  • A zero shift after an event that does not return when vented.
  • A change in sensitivity: the reading rises less or more than the applied pressure.
  • Noise or instability if the element has cracked.
  • Fluid present in the connector or the housing if there was a leak.

How it is prevented

  • Choose a sensor overpressure limit that covers the expected spikes, not just the working pressure.
  • Install dampers, restrictors or needle valves to smooth out transients.
  • Isolate the sensor during system pressure tests.
  • Pressurize gradually during commissioning.
  • Use diaphragm seals or protectors when the fluid is aggressive or pulsating.

How to verify the damage

Vent the sensor and check the zero, then compare it with a standard at several points on the scale. A sensor that has already suffered overpressure may pass at one point and fail at others, so verification at a single value is not enough. If the damage is plastic, a zero adjustment hides it but does not repair it, and the safest course is to replace the sensor.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer