The underlying problem
A link works as long as the received signal comfortably exceeds noise and interference. In an industrial plant that headroom shrinks from three sides: the signal arrives weaker, the noise is higher and conditions change over time. A sensor that worked when it was installed may stop working when a machine is moved or other equipment is added.
Common causes
- Metal in the path: structures, tanks and enclosures block or reflect the signal; reflections arrive by several paths and add or cancel depending on position, which creates very localized dead zones.
- Metal enclosure: a sensor inside a metal box with the antenna inside radiates practically nothing.
- Antenna: unsuitable orientation and polarization, or a lossy cable and connectors.
- Electrical noise: variable frequency drives, welders and switching power supplies emit wideband noise.
- Congestion at 2.4 GHz: the band most used by sensors is also occupied by Wi-Fi networks, headsets and other equipment.
- Battery: a node with low voltage transmits with less power or restarts.
- Topology: in mesh networks, a failed intermediate node leaves the nodes that depended on it isolated.
What the engineer sees
The symptoms are intermittency, data loss at certain times of day and sensitivity to small changes: bringing a hand close or moving the antenna a few centimeters recovers the link. This points to low margin and multipath, not a sensor defect.
What to check
- Received signal level and signal-to-noise ratio at the receiver, compared with the equipment’s sensitivity.
- Antenna position and orientation, and whether the antenna can be placed outside the enclosure.
- Spectrum at the site, to detect noise or occupied channels.
- Battery condition and the node’s retry statistics.
- Adding a repeater or changing the channel if the margin is insufficient.
It is advisable to carry out a site survey with measurements, because theoretical prediction does not capture the multipath caused by metal well.