What a residual current device measures
The device compares the current going in with the current coming out through the live conductors. A difference means that part of the current has taken another path, normally ground, and if it exceeds the threshold the device trips. Everything it can do, and all its limits, stem from that principle.
Situations the device does not detect
- Contact between phase and neutral: if a person touches both conductors of the same circuit, current passes through the body and returns through the neutral; the device sees that what goes in equals what comes out and does not trip.
- Contact between two phases: the same case; current flows between live conductors without passing through ground.
- Leakage below the threshold: a current lower than its sensitivity does not activate the device, even though it may be felt.
- Operating time: the device opens in a short time, but not instantly; during that interval current passes through the person.
- Overcurrents and short circuits: a pure residual current device does not protect against them; it needs associated protection.
- Special waveforms: certain device types do not detect leakage with a direct current or high-frequency component produced by electronic equipment; there are types designed for this.
Failures of the device itself
- A stuck mechanism or a degraded component may not trip, which is why there is a test button.
- A neutral connected to ground downstream of the device can cause nuisance tripping or inhibit detection.
- An installation without a protective conductor limits the faults that divert to ground.
What is seen in the field
A person who touches phase and neutral with their hands can receive a severe shock even with a residual current device installed and in good condition. That is why this device is complementary protection, not a substitute for the others: grounding, insulation, good practices, de-energizing before working.
How to interpret the protection
The device reduces one type of risk: current diverted to ground. The other risks require other measures. Testing the device and measuring leakage are part of maintenance.
Work on these installations must be done by qualified personnel, following the applicable regulations.