24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is the signal-to-noise ratio of a link?

The signal-to-noise ratio compares the power of the useful signal with the noise power at the receiver; in a link it determines how well the signal can be demodulated and, with that, which data rate and error rate are possible.

Definition

It is the ratio of the desired signal power to the noise power present in the receiver bandwidth. It is expressed in decibels, and since it is a power ratio, subtracting or adding decibels is equivalent to dividing or multiplying. The key concept is that the receiver does not simply need a “strong signal”; it needs a signal that is strong relative to the noise that accompanies it.

Where the noise comes from

  • Thermal noise: it exists in every conductor because of the agitation of charge carriers, and it grows with temperature and with bandwidth.
  • Receiver noise: the circuits add noise, which is summarized by the noise figure.
  • External noise: atmospheric, industrial and from other transmitters.
  • Interference: other signals on the same channel or on adjacent channels, which are treated as additional noise.

Since thermal noise is proportional to bandwidth, widening the channel to go faster lets in more noise. That is the origin of the trade-off between data rate and sensitivity.

Relationship to performance

The theoretical limit on the capacity of a noisy channel grows with the bandwidth and with the logarithm of the signal-to-noise ratio. For each modulation scheme there is a minimum ratio at which an acceptable error rate is achieved. Below it, errors increase rapidly; above it, improving the signal adds little, unless a denser scheme is adopted.

What the engineer observes

On a spectrum analyzer, the signal is seen rising above the noise floor, and the difference between the two gives a direct idea of the ratio. With the link in service, the quality of the constellation and the error rate confirm whether the margin is sufficient. If the ratio is low, there are three options: increase the useful power with antennas or transmit power, reduce the noise with a better receiver or a narrower bandwidth, or eliminate sources of interference.

A word of caution

It should not be confused with the received signal level. A high-level signal with strong interference can have a worse ratio than a weak signal in a quiet environment.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer