24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is incident energy?

Incident energy is the amount of thermal energy per unit area received by a surface, at a given working distance, during an arc flash; it is used to choose protective equipment and evaluate the risk.

Definition

An arc flash releases a great deal of energy in an instant. Incident energy describes how much of that energy reaches a person or a surface placed at a certain distance, expressed per unit area, generally in joules per square centimeter or calories per square centimeter. It is not the total energy of the arc, but the energy that reaches a specific point.

What it depends on

  • Available fault current: the higher the arcing current, the greater the energy release.
  • Arc duration: this is the most influential factor and depends on the operating time of the protection that clears the fault.
  • Working distance: energy decreases rapidly with distance from the source.
  • Equipment configuration: type of enclosure, spacing between conductors and electrode orientation.
  • Voltage level and grounding.

Why protection matters

Because clearing time weighs so heavily, a circuit breaker that takes longer to open can drastically raise the incident energy, even at a lower current. That is why an inadequate protection setting can be as relevant as the short-circuit level.

How it is used

  1. It is calculated or estimated through an arc flash study using a recognized method.
  2. It is compared with the protective capacity of the clothing and personal protective equipment, which is expressed in the same units.
  3. The equipment is labeled with the result and the working distance considered.

How to interpret the result

The value is an estimate that depends on assumptions; if the network, the protection or the configuration changes, it must be reviewed. High incident energy can be reduced through design, protection settings or maintenance, and not only with protective equipment.

All work on energized electrical equipment or equipment with an arc flash risk must be carried out by qualified personnel, following the applicable regulations and the facility’s safety procedures.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer