Two concepts that get confused
Channel bandwidth is an allocation: the portion of the spectrum reserved for a transmission, with limits set by regulation or by the system design. Occupied bandwidth is what the signal actually uses, which is measured on the equipment. Ideally the second fits inside the first, with a guard separation from neighboring channels. If the signal extends outside its channel, it interferes with other users.
Why it limits the data rate
A signal that changes faster occupies more spectrum. There is a fundamental relationship: the higher the symbol rate, the greater the bandwidth required. Within a given channel, the maximum symbol rate is bounded by its width, and getting more bits per second means increasing the bits per symbol through denser modulations. That requires a better signal-to-noise ratio. The theoretical capacity of a noisy channel grows in proportion to bandwidth and logarithmically with the signal-to-noise ratio, so widening the bandwidth is usually more effective than raising the power.
The cost of width
- The thermal noise picked up grows with bandwidth, so a wider channel reduces sensitivity for the same signal.
- Fewer channels are available in a band, which complicates coexistence.
- Transmitter and receiver filters must be more demanding the smaller the separation between channels.
How occupied bandwidth is measured
Definitions are used that are based on power, for example the range containing a given percentage of the total power, or on the drop from the maximum, measured a certain number of decibels below the peak. The method must be stated, because each one gives a different value for the same signal.
How to interpret the result
An occupied bandwidth greater than the allocated one, or a spectrum with high side lobes, indicates insufficient filtering or amplifier saturation, which broadens the spectrum. An occupied bandwidth far below the allocated one may indicate that the channel is underused, but it is not a defect in itself.