24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is burn-in?

Burn-in is a period of product operation, normally under elevated stress, intended to provoke and eliminate early failures before shipping to the customer.

Definition

Burn-in, or run-in, consists of operating finished products or components for a period of time, often at elevated temperature and under electrical load, so that those with latent defects fail. The units that pass have come through the most dangerous part of their life, and the customer receives units with better reliability.

Why it works

Many manufacturing defects, such as a weak solder joint, contamination or a component with an incipient fault, do not make the product fail immediately, but they do during the first hours or weeks of use. This region of early failures corresponds to the initial section of the bathtub curve. Burn-in compresses that phase into a short time, using stresses that accelerate the failure mechanisms.

What is controlled

  • Temperature: helps activate defects and accelerate reactions.
  • Electrical load and power cycles: make the product work as it does in service.
  • Duration: must be sufficient to cover the observed early failure period.
  • Functional monitoring: verifies that the product is operating, not just switched on.

A delicate point

Burn-in must not consume the useful life of healthy units. If the stress is excessive, it damages the good units; if it is insufficient, it does not reveal the bad ones. That is why duration and level are determined from real failure data and not by habit. In addition, prolonged burn-in adds cost and production time.

How it differs from other tests

It is not a design qualification test, which verifies whether the design holds up, but a production screen that detects process defects. One variant is environmental stress screening, which uses thermal cycling and vibration.

How to interpret the result

If a high percentage of units drop out during burn-in, the problem lies in the process or the design, and the cause must be corrected rather than the loss accepted. Over time, a good program reduces the need for burn-in, by improving the process until early failures disappear.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer