24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is an arc flash and why is it dangerous?

An arc flash is a sustained discharge of current through the air between conductors or to ground, releasing intense heat, light, pressure and molten metal in fractions of a second, capable of causing serious injury.

What happens physically

Air is an insulator, but a fault can break down its dielectric strength between two points. Once established, the arc turns the air into a conductive plasma through which a high current flows. The arc energy is released as radiant and convective heat, intense light, a pressure wave, noise and a spray of particles and metal vapor from the conductors and enclosures. The temperature in the arc is extremely high, far above what any commonly used material can withstand.

Why it is so harmful

  • Burns: radiant heat reaches a person at some distance, without the need to touch anything, and ordinary clothing can catch fire.
  • Pressure wave: the sudden expansion of air and vaporized metal can throw a person and cause injury.
  • Light and noise: eye and hearing damage.
  • Molten metal and vapors: further injuries from projection and inhalation.

What the released energy depends on

Mainly on the available fault current, the time the protection takes to clear the fault, the distance between the person and the arc, and the equipment configuration, for example whether it is inside an enclosure. This leads to a counterintuitive idea: a lower-current fault can be more dangerous if the protection takes longer to trip. The operating time of the protection weighs as much as the current.

How it originates

  • A tool or metal part that falls on or touches energized parts.
  • Degraded, contaminated or damp insulation.
  • Loose connections that heat up and fail.
  • Switching of circuit breakers or disconnectors on equipment in poor condition.
  • Procedural errors during the work.

How the risk is managed

A combination is used of incident energy studies, protection coordination, equipment labeling, work procedures, de-energizing and locking out whenever possible, and personal protective equipment suited to the energy level. Protective equipment is the last barrier and does not replace the previous ones.

Common mistakes

  • Believing the risk exists only at high voltage: it also occurs at low voltage with high fault currents.
  • Thinking that cotton clothing or generic protective equipment is enough without an assessment.
  • Ignoring the maintenance condition of circuit breakers and protection devices.
  • Opening enclosures with the equipment energized to “just check.”

This guide is informational and is not sufficient for working on equipment. Work on energized installations must be carried out only by qualified and trained personnel, following the applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer