What it is
A single-line diagram shows a three-phase installation with one line per circuit, instead of drawing all three phases. The phases are assumed to be symmetrical, so one line and the symbols that accompany it are enough to represent the network topology. It is the reference document for the power system.
What it contains
- Sources: utility service entrance, generators, photovoltaic plants.
- Transformers with their voltages, connection, and power rating.
- Buses, panels, and motor control centers.
- Protection and switching devices: circuit breakers, fuses, disconnect switches, and relays.
- Current and potential transformers that feed the protections and metering.
- Main loads, motors, capacitors, and filters.
- Conductors, with size and length, and the normal state of the switching devices.
What it is used for
It is the basis of almost all electrical engineering work. Short-circuit, load flow, and protection coordination studies are modeled from it. In maintenance, it makes it possible to plan outages and understand which part is left without power when a device is opened. In an emergency it helps decide what to switch, and for new personnel it is the fastest way to understand the plant.
What it does not show
It does not represent control circuits or internal wiring, and it says nothing about the physical layout, the actual location of equipment, or distances, except those noted on it. Nor does it detail load unbalance between phases.
When it is reliable
A diagram is useful only if it matches the actual installation. After years of expansions, it is common for the drawing not to reflect what is in the field: added loads, breakers replaced with different settings, panels that no longer exist. That is why it is verified with a physical survey, comparing nameplates and cable routes, and updated under change control. An outdated single-line diagram is worse than having none, because it creates a false sense of security when planning switching. Field verifications are done by qualified personnel.