24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What is a logic analyzer for debugging?

A logic analyzer captures the digital state of many signals at once over time and shows the sequence, timing and protocols of a system so that logic errors can be debugged.

What it measures

A logic analyzer treats each input as a binary value, high or low, according to a voltage threshold, and records that state over time. Its strength lies in the number of channels: it can observe dozens of lines at the same time, such as an address bus, a data bus and the control signals.

How it differs from an oscilloscope

Aspect Oscilloscope Logic analyzer
Channels Few Many
Information Analog waveform Digital state and sequence
Typical use Signal integrity, noise, levels Logic, timing, protocols

They complement each other: if a bit is read incorrectly, the analyzer shows where in the sequence; the oscilloscope shows whether the level or the edge is defective.

What it is for when debugging

  • Verifying that a sequence of signals occurs in the expected order and with the expected time separation.
  • Detecting spurious pulses (glitches) and setup and hold time violations.
  • Decoding serial and parallel protocols, such as I2C, SPI or UART, and converting pulses into readable bytes.
  • Triggering on a pattern or a combination of states to isolate a rare event.

How it is used

  1. Connect the probes and a common ground reference.
  2. Set the logic threshold according to the signal family.
  3. Choose the sampling rate, high enough relative to the fastest signal.
  4. Define the trigger condition and capture.
  5. Decode and compare with the expected behavior.

Limitations

Insufficient sampling can hide brief pulses, and a signal with a degraded level can be interpreted as the wrong state without any warning that the problem is analog. Probes add capacitive loading that, on very fast signals, can alter the very circuit being measured.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer