24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What does the IEEE 181 pulse measurement standard cover?

The IEEE 181 standard defines the terms and algorithms used to measure transitions, pulses and related waveforms, such as rise time, overshoot or pulse width, so that measurements made on different instruments are comparable.

The problem it addresses

Measuring a rise time seems simple, but it depends on decisions that each instrument may make differently: what counts as the low and high levels, where the start and end of the transition are measured, how overshoot is treated. If each manufacturer uses its own criteria, two instruments give different figures for the same signal. IEEE 181 resolves this with explicit definitions and algorithms.

What it covers in general

  • Definitions of transition, pulse, states and reference levels.
  • Transition parameters: rise and fall times, duration, overshoot and undershoot, settling, and pre-transition and post-transition aberrations.
  • Pulse parameters: width, amplitude, period and duty cycle.
  • State determination procedures: how to find the high and low levels from the data, for example using histograms, rather than from the simple maximum and minimum.
  • Uncertainty: the influence of noise and resolution on the result.

Why it matters to an engineer

Modern oscilloscopes calculate these parameters automatically. Understanding the basis of these measurements tells you why an instrument reports an amplitude different from the visible peak value: amplitude is defined between stable states, not between extremes. It also explains why overshoot is not counted as part of the high level, and why the result may vary if you change the reference percentages.

What it is not

It does not set acceptance limits for a product, nor does it cover instrument calibration. It is a standard of definitions and waveform measurement methods.

How to use it

Consult it when edge measurements must be documented or compared between instruments or laboratories, and when a discrepancy depends on the definition of the parameter. Because standards are updated, check the current edition and confirm which parameters it includes.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer