24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What does the Federal Law on Metrology and Standardization establish?

The Federal Law on Metrology and Standardization (Ley Federal sobre Metrología y Normalización) is the Mexican legal instrument that regulates the system of units, metrology, standardization, conformity assessment and accreditation. For its specific provisions, consult the current text.

This is the federal law that sets the legal framework for metrology and standardization in México. It defines the country’s general system of units of measurement, which is based on the international system, and lays the foundations for Official Mexican Standards, Mexican Standards and conformity assessment against them. This guide describes only its general scope; the current text and its amendments are the source to consult.

Areas it governs

  • Metrology: legal units of measurement, national standards and how they are maintained, and the use of measuring instruments.
  • Standardization: preparation and application of Official Mexican Standards, which are mandatory, and of Mexican Standards, which are voluntary unless compliance with them is made mandatory.
  • Conformity assessment: procedures for determining whether a product, process or service meets a standard.
  • Accreditation and approval: recognition of the technical competence of certification bodies, testing and calibration laboratories and verification units.
  • Verification and surveillance: the authority’s powers to check compliance, along with infractions and penalties.

Its role in measurement

The law underpins a national traceability system, supported by the national metrology center, and requires measurements with legal or commercial effects to be expressed in legal units. This gives a common basis to calibration certificates, to the assessment of regulated instruments and to the comparability of results.

What the engineer sees in practice

It shows up in the fact that certain official standards require calibrated instruments, in the existence of laboratories with formal recognition of competence, and in the unit and marking requirements on products. Which instruments or activities are subject to which obligations depends on the specific official standard, not on the law itself.

When it is not enough

The law is a general framework. To know what a specific instrument or process must comply with, go to the applicable official standard and its current edition and, for legal questions, to the competent authority or a specialist in the field.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer