General scope
IEC 62232 does not assess antenna performance or quality of service. Its subject is human exposure to the radio-frequency fields emitted by radiocommunication base stations. It describes how to determine field strength, power density and specific absorption rate (SAR) in the vicinity, in order to compare them with the exposure limits set by the applicable regulations.
What goes into an assessment
- Source characterization: power, antenna pattern, height, orientation and operating band.
- Calculation: propagation models that estimate the field at different points, useful for defining access zones.
- Measurement: field measured with calibrated probes or antennas, to check the calculations or assess the site.
- Combining sources: when several antennas or services coexist, their contributions are summed against the limits.
Why the antenna pattern matters
The energy from a base station antenna is concentrated in a beam, which is why exposure is not uniform around the tower. Near the base, directly below the antenna, the level is usually lower than at a certain distance in the direction of the beam. The assessment considers the lobes and the distance, not just the transmit power.
What the engineer obtains
The result is a map or a distance beyond which the field level falls below the applicable limit. This is used to define restricted access zones, signage and procedures for people working near the antennas.
How to use it
- Identify the regulatory limit in force in the country, which comes from the regulations and not from this standard.
- Apply the method suited to the type of station and the assessment phase.
- Consult the current edition, because the methods are updated.
Work near transmitting antennas must be done by qualified personnel, following the safety regulations applicable to radio-frequency exposure and work at height.