24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What does electromagnetic “susceptibility” mean?

Electromagnetic susceptibility is the tendency of equipment to degrade in operation when it receives an electromagnetic disturbance; it is the opposite side of immunity, which is the ability to resist it.

Definition

Susceptibility is a property of the equipment, not of the disturbance. It describes how easily the equipment is degraded by an unwanted signal. Highly susceptible equipment fails with weak disturbances; equipment with low susceptibility tolerates them. Immunity is the complementary term: the greater the immunity, the lower the susceptibility. In testing, the word immunity is used for the requirement and susceptibility to describe the defect.

Why it occurs

The disturbance has to reach the circuit and then be interpreted by it. It arrives by coupling: conducted along power or signal cables, radiated as a field, or capacitive and inductive between nearby traces. Once inside, nonlinear circuits such as amplifier inputs, detectors and comparators can rectify a radio-frequency signal and turn it into a DC level or low-frequency noise, even if the frequency of the disturbance is far outside the operating band.

Susceptibility increases when there are large loops, unshielded cables, high-impedance inputs, weak ground references and low-level analog signals.

How it shows up

  • Sensor readings that drift when a transmitter is nearby.
  • Momentary loss of communication that recovers by itself.
  • Processor reset or lockup that requires intervention.
  • Permanent damage, in the most severe cases.

The fact that the failure disappears when the disturbance is removed does not mean the design is correct; it only indicates a temporary defect.

How it is evaluated

The equipment is subjected to a controlled disturbance, such as a radiated field, a discharge, a fast transient or a surge, and its behavior is observed against a performance criterion defined in advance. The result depends on the function: a brief loss may be acceptable in equipment used only to look up information and not in control equipment.

When to use the term

Susceptibility is the term for analyzing the failure mechanism of a specific design, and immunity is the term for writing a requirement or reporting a test result. Mixing them causes confusion in specifications.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer