24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What does a solar charge controller do?

A solar charge controller regulates the current flowing from the PV generator to the battery to charge it without overcharging it, and usually also protects against excessive discharge and reversed connections.

Main function

A battery does not accept just any voltage or current during charging. The controller measures the battery voltage and limits the energy coming in from the modules according to the charging stage. Without it, a directly connected module can overcharge the battery during hours of good sun, with a loss of service life and a risk of damage.

Charging stages

Although they vary with battery chemistry, the general logic is to charge with the available current until a target voltage is reached, hold that voltage while the current tapers off, and then move to a lighter maintenance stage. Lead-acid and lithium batteries require different profiles and voltages, so the controller must be configured for the actual chemistry.

PWM and MPPT

  • PWM: connects the generator to the battery and modulates the connection time; the generator works at a voltage close to that of the battery, which does not take advantage of its full potential.
  • MPPT: incorporates a DC-DC converter that keeps the generator at its maximum power point and delivers a matched voltage to the battery. It allows the use of a generator with a higher voltage than the battery.

Usual protection functions

Besides limiting charge, many controllers include low-battery-voltage disconnect, protection against reverse polarity and against reverse current at night, and temperature compensation, since the correct charging voltage varies with temperature. Some log energy data for diagnostics.

What to check first if something fails

If the battery does not charge, first measure the generator voltage with sufficient irradiance, then the battery voltage, and compare with the configured parameters. A deeply discharged battery may be rejected by some controllers. A wrong chemistry setting explains many cases of incomplete charging or overcharging.

Notice

Any work on an energized PV array, with DC voltages that are not interrupted by opening a disconnect on the AC side, must be carried out by qualified personnel, following the applicable electrical safety regulations. In systems with batteries, the stored energy also presents risks that require qualified personnel.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer