24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

What are a failure mode and its effect?

The failure mode is the way in which a component or function stops fulfilling its purpose; the effect is the consequence of that failure for the system and for the person using it.

Two concepts that get confused

The failure mode describes how the loss of function manifests itself: a capacitor can fail open, shorted or with degraded capacitance. The effect is what that failure causes at the next level up: a filter that lets ripple through, a fuse that opens, equipment that shuts down.

Mode, cause and effect are not the same

  • Cause: why it happened (overvoltage, heat, vibration, wear).
  • Mode: how the element fails (open, short, drift, intermittent).
  • Effect: what consequence it has for the system’s function.

The same cause can produce different modes, and the same mode can have different causes. That is why it is best to write them down separately.

Why the effect depends on context

The effect is not a property of the component, but of where it is. An open resistor in a feedback line can drive a power supply to a wrong output voltage; the same open resistor in an indicator light only turns off an LED. The analysis always considers the local effect, the effect at the next level and the end effect.

What an engineer sees in practice

When checking a damaged circuit board, the technician observes effects: missing voltages, heating, an open fuse. From these, the technician reasons backward to infer which failure modes explain them and which are most likely given the design. Knowing the typical modes of each type of component greatly shortens the search.

How it is used

Listing the modes and their effects makes it possible to decide where to place protections, which signals to monitor and which spare parts are worth holding. It is the basis of failure mode and effects analysis, which systematizes this list for an entire design.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer