24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is the homogeneity of a laminate verified?

The homogeneity of a laminate is verified by comparing a property at different points and layers, and by complementing this with non-destructive inspection and cross-sections, to detect voids and variations in thickness and in resin or reinforcement content.

What homogeneous means in a laminate

A laminate combines reinforcement, such as glass or carbon fiber, with a resin matrix in layers. It is homogeneous when its properties do not change significantly from one point to another or from one layer to another. Typical causes of poor homogeneity are uneven resin distribution, air voids, incomplete curing and reinforcement misalignment.

Dimensional verification

Measuring the thickness on a grid of points reveals gradients and resin-poor or resin-rich zones. It is a quick first filter: a variation in thickness almost always goes with a variation in reinforcement fraction.

Property mapping

  • Electrical: permittivity or resistivity at several points with small electrodes. If the laminate is for high frequency, the variation in permittivity between zones directly affects the behavior of the printed lines.
  • Mechanical: specimens taken from different positions, with the same orientation.
  • Thermal: the glass transition temperature makes it possible to detect variations in degree of cure.

Non-destructive inspection

Immersion or contact ultrasound detects voids and delaminations because air strongly attenuates or reflects the wave. Transillumination inspection is useful for translucent laminates. Active thermography can show near-surface defects through differences in thermal diffusion.

Sections and analysis

A polished section viewed under the microscope shows the fiber distribution, the layer arrangement and the void percentage. For resin and reinforcement content, calcination or dissolution of the matrix is used, depending on the material.

How to interpret the scatter

Compare the variation between points with the variation the method itself gives on a uniform sample. If the scatter of the laminate does not exceed that of the method, there is no evidence of poor homogeneity. A systematic pattern, such as edges that differ from the center, points to the manufacturing process.

What to check first

Start with the thickness map and ultrasonic inspection: they are the least expensive and they show where to cut and where to measure properties.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer