24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How Is Wireless Communication Validated in a Vehicle?

To validate wireless communication in a vehicle, the performance of the radio is measured as installed in the complete vehicle, in motion and in operation, because the body, the antenna and the vehicle's own electronics change the result.

Why testing the module is not enough

A vehicle is a difficult environment for radio. The metal body is both a shadow and a ground plane; cables and harnesses couple to the antenna; electrical systems generate noise, and the vehicle moves between very different environments. Validation must be done with the system installed, not with the module on its own.

What is evaluated

  • Antenna on the vehicle: its location, its ground plane and its effective radiation pattern. An antenna on the roof has a different pattern from one on the glass or in the plastic bumper.
  • Cable and connector losses between the equipment and the antenna.
  • Self-interference: ignition, electric motors, converters and displays can raise noise in the receive bands. The noise floor is compared with the vehicle off, on and in operation.
  • Coexistence: several radios on the same vehicle, such as cellular, GNSS, Wi-Fi and Bluetooth, affect one another.
  • Mobility: movement causes rapid variations and changes of cell or access point; it is validated that the equipment maintains service during these changes.

How it is tested

In a controlled environment, with the vehicle on a platform or at an open test site, radiated power and sensitivity are measured in different directions to obtain the actual pattern. Road tests are then carried out, logging signal, quality, errors, throughput and position with a timestamp, on routes that include urban, open and obstructed areas.

How to interpret the result

Road results vary with traffic, weather and network infrastructure, so a single run proves nothing. The test is repeated under different conditions and the results are compared against a criterion defined in advance, such as the percentage of time with acceptable service. Differences between the measured and expected patterns point to location or ground plane problems.

Safety and scope

Tests in motion must be carried out by trained people, with the vehicle in a safe condition and in compliance with traffic rules. Radio validation does not replace the electromagnetic compatibility or functional safety tests required by the automotive industry.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer