24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is an outdoor product validated?

An outdoor product is validated by identifying the environmental factors it will face, translating them into representative tests and verifying function and degradation after combined exposure.

The starting point

Validation begins with the environment, not with the test catalog. The questions are where the product will be installed, how long it must operate and what happens if it fails. From that comes an environmental profile that serves as the basis for choosing tests and severities.

Typical outdoor factors

  • Temperature: extremes and daily and seasonal variations, plus solar heating of the enclosure.
  • Solar radiation: degradation of plastics, paints and seals, and additional heat.
  • Water: rain, splashing, condensation and, in some locations, temporary immersion.
  • Dust and sand: abrasion and particle ingress.
  • Corrosion: marine and industrial environments, or those with contaminants.
  • Mechanical: wind, vibration, impacts and handling.

How they translate into tests

Each factor has its method: temperature and humidity cycling, simulated light exposure, water and dust ingress tests, salt spray, and vibration or shock. It is better to apply them in a reasoned sequence than in isolation, because one factor sets up the damage that another reveals. A seal aged by solar radiation may later fail the water test.

Function during and after

You must define whether the product has to operate during exposure or only survive it. Functional parameters are verified before, during where possible, and after. Signs of degradation such as color change, cracks, corrosion, leaks and deformation are also inspected.

What limits validation

Laboratory tests are simplified models and accelerate certain mechanisms. They do not cover all simultaneous factors or installation variability. For that reason they are complemented with field experience, inspections of installed units and, where possible, real exposure tests.

How to interpret the result

Passing means that, under the conditions tested, there was no failure against the criterion. The profile, samples, methods and deviations are documented. If the real environment is more severe than assumed, the validation loses its meaning, so the profile must be reviewed whenever the use changes.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer