The logic behind the order
Improvised diagnosis swaps parts until the equipment works again, and often hides the real cause. A step-by-step method avoids wasted time because each test narrows the set of possible explanations.
The steps
- Describe the symptom precisely: what fails, when, how often and what changed beforehand. “It won’t turn on” and “it shuts down after ten minutes under load” lead down different paths.
- Gather information without intervening: history, diagrams, records, operator accounts, inspection by sight and smell (burn marks, corrosion, deformation).
- Check the basics: power supply, fuses, connections, settings. A significant fraction of faults are resolved here.
- Form hypotheses: rank them by probability, ease of testing and risk.
- Test to rule out: design measurements that separate one hypothesis from another, and divide the system into blocks to isolate the defective area.
- Confirm the cause: distinguish the damaged component from the condition that damaged it.
- Correct and verify: repair, operate again under the conditions that caused the fault and confirm that it is gone.
- Document: record the symptom, cause, action and result.
What an engineer sees in practice
Measurements rarely give a direct “yes” or “no”; they give a clue. A low voltage may come from the supply or from a load dragging it down. That is why each measurement is compared with what it should be, according to the diagram or a healthy piece of equipment.
What to check first
Before opening the equipment, it is worth asking whether anything has changed: a previous repair, a modification, an environmental change, a new load. Many faults have a recent triggering event.
When the procedure involves energized circuits or hazardous voltages, it must be carried out by qualified personnel following the applicable regulations.