24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How do you safely measure a power signal with an oscilloscope?

Use a probe suited to the voltage and the measurement category, normally a differential probe, with the oscilloscope properly grounded and without ever defeating the protective connection, and have the work done by qualified personnel.

Why the oscilloscope is a hazard

Most oscilloscopes connect the shield of their inputs to ground through the power cord. When the ground clip of a conventional probe is connected to a point in the circuit, that point becomes referenced to ground. If the point is at a different potential, a short circuit occurs through the instrument, with a risk of damage, arcing and injury.

Principles of a safe measurement

  • Never defeat the protective ground of the oscilloscope, whether with adapters or by removing the ground pin. This practice leaves the enclosure and connectors exposed to hazardous voltage.
  • Understand the circuit: know which points are referenced to the mains, which are floating, and what potential each one is at with respect to ground.
  • Use probes with the appropriate voltage rating and measurement category, and accessories in good condition.
  • Prefer differential probes or instruments with isolated channels when no point in the circuit can be connected to ground.
  • Do not exceed the maximum voltage of the probe or the input, and take switching peaks into account, not just the RMS value.

What you see in practice

A differential probe provides an attenuated signal proportional to the difference between two points; bandwidth and common-mode rejection determine the quality in fast-switching circuits, where common-mode voltage swings are large. With the long ground lead of a passive probe, oscillations appear on the edges that do not exist in the circuit.

What to check first

  1. De-energize before connecting and wait for the capacitors to discharge.
  2. Check the condition of the leads, the probes and the oscilloscope’s ground.
  3. Connect with the circuit de-energized, with the tips secure and with hands away from live parts.
  4. Energize, measure, de-energize and disconnect.

Warning

Measurements on power or high-voltage circuits must be performed only by qualified personnel, following the applicable safety regulations and using the corresponding personal protective equipment.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer