24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is an environmental qualification plan prepared?

An environmental qualification plan is prepared by defining the product and its life environment, the failure modes to uncover, the test sequence, the sample size, the acceptance criteria and the documentation of results.

What the plan is

It is the document that, before anything is tested, states what is going to be demonstrated, how, and by what criterion it will be considered achieved. It avoids later disputes and forces you to think about the product and its use before booking the chamber.

Steps to build it

  • Define the product and its configuration, including the hardware and software version to be tested.
  • Describe the life cycle: storage, transport, installation and use, with the environments of each stage.
  • Identify likely failure modes with a prior risk analysis, to direct the tests at what can really break.
  • Choose methods and severities from standards, customer specifications or the real profile.
  • Define the sequence: which samples go through which tests and in what order.
  • Establish the sample size and its justification.
  • Set acceptance criteria for function and inspection.

Points that are often forgotten

Instrumentation and monitoring during the test: without them, an intermittent failure goes unnoticed. The state of the product during exposure, operating or switched off. The baseline measurements taken beforehand. The traceability of the test equipment and its calibration. And what to do when a sample fails: whether it is repaired, analyzed or the program is stopped.

Sample size

A single unit that survives says little about lot variability. The reasonable approach is to base it on risk, cost and, if statistical confidence is wanted, on a reliability model. With few samples, you must be clear about what can be claimed.

How to close the loop

The plan defines the report format: results, deviations, failure analysis and conclusions. It also establishes how later design changes are managed: which ones require tests to be repeated and which do not. A qualification without change control loses validity when the product is modified.

A good indicator

If someone outside the project can read the plan and repeat the test, and if the acceptance criteria need no interpretation, the plan is well written.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer