24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is continuous monitoring carried out during the work?

Continuous monitoring during the work is carried out by keeping a switched-on, verified multi-gas detector in each entrant's breathing zone, with alarms active, readings recorded and one clear rule: on an alarm, get out first and investigate afterward.

Why an initial measurement is not enough

The pre-entry test describes the space at that moment. After that, the atmosphere changes: sludge is disturbed, coatings are applied, welding starts, ventilation stops, the temperature rises or gas arrives from a leak no one had seen. Continuous monitoring exists to detect that change as it happens.

How it is organized

  1. Verify the equipment before entry. A functional test with reference gas and a check of battery, pump and alarms.
  2. Measure from outside before opening the entry, and again on opening it and while advancing, at several levels.
  3. Wear the detector on the body. The sensor must be close to the nose and mouth, where breathing takes place, not hanging at the waist or left at the entrance.
  4. Keep alarms active and set according to the procedure; never silenced for working convenience.
  5. Record readings at intervals and whenever there are changes: time, value, location. Many instruments store an internal log.
  6. Watch from outside. The attendant can observe an area detector or the transmitted reading.

What to look for in the readings

  • Oxygen rising or falling: a change in either direction is a warning.
  • The trend of combustibles and toxics, not just the spot value.
  • Differences between levels, because gases stratify.
  • Readings that behave strangely, such as jumps with no cause, which suggest a faulty sensor.

What to do on an alarm

Evacuate by the planned route, notify the attendant, and do not re-enter until the cause has been identified and corrected and the measurements have been repeated. An alarm dismissed as “false” without checking is a frequent source of accidents.

When the requirements change

If the work changes, for example when welding begins, the hazards and alarms are reviewed. If work in the space is interrupted for a break, it is measured again on return. Detectors must be kept calibrated and their operation proven in line with the program. Monitoring and entry are the responsibility of trained, authorized personnel, in accordance with applicable regulations.

This guide is for information only. Work involving electrical hazards, heights or hazardous atmospheres must be carried out by qualified, authorized personnel in accordance with applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer