24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is differential pressure measured across a filter?

Differential pressure across a filter is measured with two taps, one before and one after the filter element, connected to a differential sensor; the difference grows as the filter gets dirty and is a guide to when to replace it.

What the measurement indicates

When a fluid passes through a filter, the filter offers resistance to flow, and the pressure downstream is lower than upstream. That drop is the differential pressure. With use, retained particles clog the element, the resistance increases and the difference grows. That is why it is used as an indicator of filter saturation.

How it is measured

  1. Two taps. One before the filter and one after it, preferably on straight sections, away from elbows or valves that generate turbulence.
  2. A differential instrument. It can be a differential pressure gauge, a column or piston indicator, or a differential pressure transmitter. Each port is connected to one of the taps.
  3. A valve manifold. It makes it possible to isolate the instrument, equalize the ports to check the zero and vent without interrupting the process.
  4. Bleeding or venting the lines. In liquids, air in one line and not the other produces an error from unequal columns. In gases with condensate, the liquid produces the same effect.

What influences the reading

  • Flow rate. For a given filter, the pressure drop increases with flow. Comparing readings only makes sense at a similar flow rate.
  • Fluid viscosity and temperature. A cold oil generates more differential pressure than the same oil when hot.
  • Filter condition. A new filter already has an initial drop; the change is evaluated against it.

An example

A hydraulic filter shows a high differential in the morning, with cold oil, and a normal one after warm-up. This does not indicate that it is clogged, but rather the effect of viscosity. By contrast, a differential that rises steadily at constant flow and temperature does indicate fouling.

Common errors

  • Taking a single reading with no clean-filter reference.
  • Ignoring the flow rate when comparing against a replacement criterion.
  • Impulse lines with air or condensate.

How to interpret the result

The trend over time matters more than an isolated reading. A sharp increase can indicate a sudden blockage; a sudden drop can indicate a ruptured filter element or an open bypass. The limit for replacing the filter is given by the element manufacturer.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer