What you are looking for
Current draw is a direct indicator of what is happening on a board. Excessive draw suggests a partial short circuit or a damaged component; very low draw suggests that a stage is not starting. Measuring it and comparing it with a healthy board guides the search.
Ways to measure
- Multimeter in series: the power supply line is broken and the instrument is inserted. It is accurate for stable currents, but it adds a voltage drop due to its internal resistance.
- Shunt resistor with oscilloscope or multimeter: the voltage drop across a small resistor of known value is measured, and the current follows from Ohm’s law. This makes fast variations visible.
- Current clamp: avoids opening the circuit, although its sensitivity at very small currents is limited.
- Bench power supply with current limit: shows the draw on its display and protects the board if there is a short.
Procedure
- Establish the normal draw from a healthy board or the datasheet.
- Power the board at nominal voltage with a low current limit, to avoid further damage.
- Measure the draw at idle and in operation, and observe whether it is stable or moves.
- If it is high, isolate by blocks, disconnecting loads or removing components to see which one reduces the draw.
- Complement with thermography: the area that heats up the most is usually the one drawing the most.
How to interpret the result
Constant high draw points to a short or a permanent leak. Draw that rises over time suggests a component that heats up and degrades. Oscillating draw may be due to repeated processor resets. The instrument must have enough bandwidth for the type of variation.
If the board operates at high voltages or is connected to the mains, the work must be carried out by qualified personnel in accordance with applicable regulations.