24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How Do You Locate a Fault in an Underground Cable?

A fault in an underground cable is located in stages: confirm the type of fault, estimate its distance from one end, and finally pinpoint it along the route.

A staged process

Digging blindly along hundreds of meters of route is costly, so location works from the general to the specific. Each stage reduces the uncertainty of the next.

1. Characterize the fault

Insulation resistance and continuity measurements on each conductor determine whether the fault is an open circuit, a dead short or a high-resistance fault, and whether it affects one or several phases. This diagnosis decides which method will work: a high-resistance fault does not reflect a low-energy pulse well and needs a different approach.

2. Prelocate

This step estimates how far the fault is from the end of the cable.

  • Time-domain reflectometry: a pulse is sent and the echo time is measured; impedance discontinuities, such as a break or a short circuit, reflect part of the signal. Converted using the cable’s propagation velocity, the time gives a distance.
  • Arc reflection methods: a high-voltage impulse strikes an arc at the fault and makes it visible to the reflectometer, which is useful with high-resistance faults.
  • Bridge methods: these compare the resistances of cable sections and calculate the distance, provided a sound reference conductor is available.

3. Pinpoint the location

With the route identified using a route locator, a repetitive high-voltage impulse is applied. At the fault point a discharge occurs that is detected as sound or by an electromagnetic signal; the technician walks the route to the maximum.

What the engineer sees

Prelocation accuracy depends on knowing the actual length, the splices and the propagation velocity of the cable. It is advisable to confirm the location with more than one method before digging.

This work involves high voltage and energy stored in the cable; it must be done only by qualified personnel, with grounding and discharge verified and in accordance with applicable regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer