24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is an onboard charger diagnosed?

Diagnosing an onboard charger involves comparing the AC input power with the DC output power, verifying communication with the station, and reviewing fault codes, temperatures and insulation.

What an onboard charger does

The onboard charger converts alternating current from the grid into direct current for the high-voltage battery. It normally has a power factor correction stage followed by an isolated DC-DC converter, with its own control that coordinates with the battery management system. Knowing this organizes the diagnosis: the fault may be in the input, the conversion, the output or the communication.

Diagnostic sequence

  1. Read fault codes with the vehicle’s diagnostic tool and record the freeze-frame data from the moment of the event.
  2. Verify the station: with a simulator or a station tester, confirm that the control pilot and proximity signals are correct, because an onboard charger does not start if the station does not declare available current.
  3. Measure the input: voltage, current and power factor with a power analyzer, to see whether the charger is drawing what it should.
  4. Measure the output: voltage and current to the battery, if access allows, or use the vehicle data.
  5. Compare power values: the difference between input and output is the losses. Abnormally low efficiency points to an internal problem.

What is observed

A charger that reduces power as it heats up usually indicates a cooling or thermal assembly problem. Charging that starts and stops after a few seconds may be due to communication failures, a detected leak or the battery requesting that charging stop. Analysis of the AC side also shows whether there is distortion or imbalance that the equipment does not tolerate.

What to check first

Before blaming the charger, rule out the station, the cable and the outlet, and check the voltage of the 12 V battery: many units do not start if the auxiliary system is weak. Work on the vehicle’s high-voltage circuit must be performed by qualified people following the manufacturer’s procedure.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer