24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is a circuit board designed for EMC compliance?

It is designed by controlling three things: the return path of each current, the area of the loops they form and the speed of the edges. A continuous reference plane, close decoupling and filtering at the connectors solve most problems.

Guiding principle: all current returns

A fast signal does not just travel along the trace; its current must return to the source, and at high frequencies it does so along the path of lowest impedance, that is, directly beneath the trace if there is a continuous plane. The area between the outgoing and return paths determines how much the circuit radiates and how much it picks up. Almost all design rules aim to reduce that area.

Stackup and planes

  • Place a solid reference plane adjacent to each layer of fast signals.
  • Avoid cutting or fragmenting the plane under critical traces: a slot forces the return to go around it and creates a large loop.
  • When a signal changes layers, add ground vias nearby so that the return changes plane without a detour.

Decoupling and power

Decoupling capacitors must be very close to the power pins of the integrated circuit, with a short, low-inductance connection to the planes. The inductance of the connection limits their usefulness more than their capacitance value does. A switching power supply must have a compact power loop.

Partitioning and edges

Group circuits by function: clock and fast digital, sensitive analog, power, interfaces. Keep noisy circuits away from the connectors and the edges of the board. Use the slowest edge the system allows, because the emitted spectrum depends on the transition speed, not just the clock frequency; series resistors on outputs help.

Connectors and cables

Cables leaving the equipment are the most efficient antennas. Filter or protect each line leaving the board at the point of entry, with the filter reference connected to a chassis ground or a low-noise ground, and keep noisy signals away from the connectors.

A verification example

Before fabrication, review the design by following each fast signal along with its return: look for slots, layer changes without return vias and traces close to the edge. Then, on the prototype, measure emissions with near-field probes to confirm there are no surprises before the formal test.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer