24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is air bled from a hydraulic test circuit?

Air is bled by filling the circuit from the lowest point, venting at the high points and moving the fluid until it comes out free of bubbles, because air is compressible and makes pressure tests slow and unstable.

Why air must be bled

Liquids barely compress; gases do. An air bubble in a hydraulic test circuit acts like a spring: it absorbs pumped volume before the pressure rises, makes the pressure slow to stabilize, produces unstable readings and delays leak detection. It also stores energy: if the circuit fails, the compressed air releases that energy all at once and the failure is more violent than with a liquid.

How to bleed it

  1. Design the installation with air in mind. Place vent points at the highest points and avoid sections that form pockets.
  2. Fill from the bottom. Filling the circuit from its lowest point pushes the air upward, toward the vents.
  3. Open the vents. Keep the high points open until the fluid flows continuously and without bubbles.
  4. Move the fluid at low pressure. Circulate the fluid or vary the pressure gently to carry away trapped air; tilting or tapping carefully helps release clinging bubbles.
  5. Repeat. Close, pressurize slightly and vent again. This may take several cycles.
  6. Use a suitable fluid. A liquid with dissolved air releases it when the pressure falls; letting the fluid rest or deaerating it helps.

How to tell if air remains

  • The pump needs much more volume than expected to raise the pressure.
  • When the circuit is isolated, the pressure falls slowly with no apparent pattern, or recovers over time.
  • Readings oscillate or stabilize very slowly.
  • On depressurizing, more fluid than expected comes out, or it comes out with bubbles.

An example

When testing a component with an upper cavity, air collects at the top even if the circuit is filled properly. Without a vent at that point, the pressure lags no matter how much you pump. By adding the vent and repeating the fill from the bottom, the behavior becomes fast and repeatable.

What to check first

Before looking for a leak in a circuit that does not hold pressure, rule out trapped air and thermal effects.

Safety

Before opening vents or disconnecting, the circuit must be safely depressurized. A jet of high-pressure liquid can cause serious injury. The work must be done by qualified personnel, with the applicable protective measures and procedures.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer