24/7 emergencies 814 777 6921812 230 6079WhatsApp 811 786 0768
Electrónica MonterreyElectrónica MonterreyLaboratorios Creativeit Talk to an engineer
Menu

How is EMC applied in electric vehicle design?

In an electric vehicle, electromagnetic compatibility is applied from the design stage because the traction inverter, the charger and the converters switch high currents and coexist with radio, sensors and data networks inside the same vehicle.

Why the electric vehicle is a demanding case

An electric vehicle combines, in a small space, fast-switching power electronics and sensitive electronics: radio receivers, driver-assistance sensors, wireless communications and data buses. The fast edges of the inverter and converter transistors generate broadband noise, and long power cables work as efficient antennas.

Main sources of disturbance

  • Traction inverter: it switches the battery to the motor and produces common-mode currents that flow through the chassis and through the parasitic capacitances of the motor.
  • DC/DC converters and charger: they add conducted noise toward the battery, toward the grid during charging and toward the low-voltage network.
  • Controllers and regulators on the low-voltage network: less powerful, but close to sensitive circuits.

How it is addressed in design

The approach goes from the source to the receiver. First, generation is reduced: control of edge speed, compact power module layout and small current loops. Then propagation is limited: filters at inputs and outputs, shielded power cables with the braid connected to the chassis at both ends by a 360-degree termination, and separate routes for power and signal. Finally, the receiver is protected: shielding of sensitive modules, input filtering and a good ground reference.

The metal chassis or conductive housing acts as a reference plane. Bonding points must have low impedance, because a long braided ground connection becomes inductive at the frequencies that matter.

Charger and external environment

During charging, the vehicle connects to the grid and to external infrastructure. Conducted emissions, harmonic distortion and immunity to grid disturbances are evaluated at that point, along with compatibility with the charging equipment.

What is seen in testing

Radiated and conducted emission from the vehicle and its components is measured, and immunity to external fields and to transients on the low-voltage network is verified. The typical symptom of a problem is noise on the AM or FM radio that appears only when the motor is under load, or unstable sensor readings with power active. Each finding is traced to the cable or module acting as an antenna or source.

Work on the vehicle’s high-voltage systems must be performed only by qualified personnel, following the applicable procedures and safety regulations.

We do real tests, on video! Watch them on our YouTube channel →

Do you have a problem nobody has been able to measure?

Talk directly to the engineer in charge, with no middlemen.

Talk to an engineer