What the test sets out to answer
The test verifies whether dust penetrates a piece of equipment’s enclosure and whether that penetration affects its operation or safety. The result is a consequence of the sealing, the gaskets, the cable glands, the vents and the geometry of the housing.
Equipment and conditions
- Dust chamber: keeps the dust circulating or in suspension, normally with a fan or air.
- Test dust: of the type and particle size distribution specified by the standard, because particle size governs penetration.
- Internal pressure: some variants hold a vacuum inside the enclosure, which draws dust toward the gaps; in others no pressure difference is applied.
- Duration and concentration: defined by the applicable procedure.
Sequence
- Prepare the sample as it will be used: with its gaskets, cables, connectors and entries.
- Weigh it, photograph it and, where applicable, verify its initial operation.
- Mount it in the defined position inside the chamber.
- Expose it for the specified time.
- Remove it carefully, clean the outside without pushing dust inward and open it in a controlled environment.
- Inspect the interior: where deposits are, how much dust there is and whether it affects critical parts.
- Verify operation.
What the engineer sees
Deposits tend to concentrate around deformed gaskets, cover joints, cable entries and breathing areas. It is useful to distinguish dust that merely settles from dust that reaches contacts, switches or moving parts. What counts is the acceptance criterion defined in advance, because a certain amount of dust may be allowed if it does not compromise operation or safety.
Relationship to the IP code
The first digit of the IP code indicates the degree of protection against solids and includes the dust resistance categories. The rating is based on tests defined by the corresponding standard, whose current edition should be consulted.